Test Sequence Application 7
Keysight U8903B User’s Guide 351
SMPTE frequency sweep
SMPTE frequency sweep measurement will hold one of the two tones at a fixed frequency
while the other is swept through a range of frequencies. The results are displayed on an X-Y
graph, with the swept frequency on the X-axis and the measured SMPTE ratio on the
Y-axis.
Refer to “Measurement Results” on page 399 for more information on the respective result
menu page. Use the arrow keys to navigate through the respective tabs and to display the
menu page.
Signal generation
The SMPTE frequency sweep signal generation settings menu page is displayed as shown
in Figure 7-39.
Figure 7-39 SMPTE Frequency Sweep > Signal Generation settings menu page
This measurement requires a closed-loop configuration in which both the generator and
the analyzer are used in the test setup. If None is selected for the output configuration
channel, this measurement is unavailable.
The signal generation is disabled if None is selected for the output configuration channel.
To Next Page
Loading...
