Keysight U8903B - Table 7-56 Measurement Recorder > Signal Generation Settings Menu Description

Test Sequence Application 7
Keysight U8903B User’s Guide 391
Signal generation
The measurement recorder signal generation settings menu page is displayed as shown in
Figure 7-58.
Figure 7-58 Measurement Recorder > Signal Generation settings menu page
NOTE
The signal generation is disabled if None is selected for the output configuration channel.
Table 7-56 Measurement Recorder > Signal Generation settings menu description
Menu Description
Waveform
Press the Waveform softkey to select the waveform type.
–Sine
– Variable Phase
– Square
– Arbitrary
Output Press the Output softkey to select the output channel.
Waveform Config
Press the Waveform Config softkey to set the waveform configuration.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
– Frequency
Set the frequency value.
–Amplitude
Set the amplitude value.
–DC Offset
Set the DC offset value.