Keysight U8903B - Plot Settings; Table 6-6 Sweep > Plot View > Plot Settings Menu Description

Sweep Function 6
Keysight U8903B User’s Guide 287
Plot settings
Figure 6-7 Sweep > Plot View > Plot Settings menu page
Table 6-6 Sweep > Plot View > Plot Settings menu description
Menu Description
Data Channel
Press the Data Channel softkey to select the trace data channel number to be plotted. This setting is only available when
the measured channels are more than one channel.
Y Data
Press the Y Data softkey to select the Y-axis trace data source.
– S: <sweep parameter>
– F1: <measurement function 1>
– F2: <measurement function 2>
– F3: <measurement function 3>
– F4: <measurement function 4>
Y2 Data
Press the Y2 Data softkey to select the second Y-axis trace data source.
– S: <sweep parameter>
– F1: <measurement function 1>
– F2: <measurement function 2>
– F3: <measurement function 3>
– F4: <measurement function 4>
X Data
Press the X Data softkey to select the X-axis trace data source.
– S: <sweep parameter>
– F1: <measurement function 1>
– F2: <measurement function 2>
– F3: <measurement function 3>
– F4: <measurement function 4>