Keysight U8903B - Appendix 4: Analog Generator Menu Tree; Table A-4 Analog Generator Menu Tree Description

A Appendixes
428 Keysight U8903B User’s Guide
Appendix 4: Analog Generator Menu Tree
Table A-4 Analog generator menu tree description
Level 1 Level 2 Level 3 Description
Waveform
–Sine
– V. Phase
–Dual
– SMPTE 1:1
– SMPTE 4:1
– SMPTE 10:1
– IEC 60118
– IEC 60268
– Gaus. Noise
–Rect. Noise
– Pink Noise
– Square
–DC
– Sine Burst
– Arbitrary
– Multitone
–DTMF
Select the waveform type.
Waveform Config
(Sine)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
DC Offset Set the signal DC offset value.
Waveform Config
(V. Phase)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
Phase -> 1
This is only available when the analog generator is in channel 2.
Set the phase of the channel 2 sine waveform with reference to channel 1.
Waveform Config
(Dual)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
Frequency 2
Set the second sine wave signal frequency value.
This setting is only applicable for the dual waveform.
DC Offset Set the signal DC offset value.
Ratio
Set the ratio of the amplitude of the second sine wave over the first sine
wave.
Summation
–RSS
– Linear
Summation refers to the method to sum up two levels.