Keysight U8903B - Page 429

Appendixes A
Keysight U8903B User’s Guide 429
Waveform Config
(SMPTE 1:1/4:1/10:1)
Amplitude Set the signal amplitude value.
Lower Freq Set the lower frequency value.
Upper Freq Set the higher frequency value.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two levels.
Waveform Config
(IEC 60118)
Amplitude Set the signal amplitude value.
Upper Freq Set the higher frequency value.
Diff Freq Set the difference frequency of the waveform.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two levels.
Waveform Config
(IEC 60268)
Amplitude Set the signal amplitude value.
Center Freq Set the center frequency of the waveform.
Diff Freq Set the difference frequency of the waveform.
DC Offset Set the signal DC offset value.
Summation
–RSS
– Linear
Summation refers to the method to sum up two levels.
Waveform Config
(Gaus. Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Rect. Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Pink Noise)
Amplitude Set the signal amplitude value.
DC Offset Set the signal DC offset value.
Waveform Config
(Square)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
Waveform Config
(DC)
Voltage Set the signal voltage value.
Waveform Config
(Sine Burst)
Amplitude Set the signal amplitude value.
Frequency Set the signal frequency value.
DC Offset Set the signal DC offset value.
Burst On Set the number of cycles at which the amplitude is at the highest level.
Period
Set the number of cycles from the beginning of one burst to the beginning
of the next burst.
Low Level Set the amplitude ratio of Burst On over Burst Off.
Table A-4 Analog generator menu tree description (continued)
Level 1 Level 2 Level 3 Description