Keysight U8903B - Generator; Table 8-4 HP8903 B > Generator Menu Description

8 HP8903B
412 Keysight U8903B User’s Guide
Generator
Select Generator in the HP8903B menu page to configure the HP8903B generator settings.
Figure 8-3 HP8903B > Generator menu page
NOTE
The generator in the HP8903B generates sine waveform.
Table 8-4 HP8903B > Generator menu description
Menu Description
Frequency
Press the Frequency softkey to set the HP8903B generator frequency value. Changing the frequency value will also set the
step parameter to frequency.
Amplitude
Press the Amplitude softkey to set the HP8903B generator amplitude value. Changing the amplitude value will also set
the step parameter to amplitude.
Step Param
Press the Step Param softkey to select the HP8903B generator step parameter type.
– Frequency
– Amplitude
Freq. Step
Press the Freq. Step softkey to set the HP8903B generator frequency step value. This setting is only available when the
step parameter is set to frequency.
Amp. Step
Press the Amp. Step softkey to set the HP8903B generator amplitude step value. This setting is only available when the
step parameter is set to amplitude.
x 10 Press the x 10 softkey to multiply the current parameter step value by 10.
÷ 10 Press the ÷ 10 softkey to divide the current parameter step value by 10.