Keysight U8903B - Figure 1-8 System > Service > Self-Test Menu Page; Perform Self-Test; Table 1-7 System > Service > Self-Test Menu Page

1 Getting Started
48 Keysight U8903B User’s Guide
Perform self-test
Perform the following procedure to run the U8903B self-test.
1 Press on the SYSTEM panel.
2 From the System menu page, press the Service softkey.
3 From the Service menu page, press the Self-Test softkey. The Self-Test menu page is
displayed as shown in Figure 1-8.
4 Press the Customize Test softkey to select the desired tests.
5 Press the Run Test softkey to run the slected tests.
Figure 1-8 System > Service > Self-Test menu page
Table 1-7 System > Service > Self-Test menu page
Menu Description
Customize Test
Press the Customize softkey to select or deselect the desired tests.
–LAN Test
–Card Self Test
Run Test Press the Run Test softkey to run the selected tests.
Clear Result Press the Clear Result softkey to clear the previous self-test results. The self-test results are saved in the system memory.
NOTE
The System menu page is only available in the Standard mode. Refer to “Menu Key” on
page 60 for more information on the U8903B available modes.