Keysight U8903B - Table 2-18 System > I;O > Lan Settings Menu Description

Operation and Features 2
Keysight U8903B User’s Guide 85
In the Lan Settings menu page, you can reset the LAN, change the hostname, and switch
between automatic or manual configuration mode as shown in Figure 2-28.
Figure 2-28 System > I/O > Lan Settings menu page 1
Update
Refer to “Update the U8903B” on page 46.
Table 2-18 System > I/O > Lan Settings menu description
Menu Description
Reset Press the Reset softkey to reset the LAN settings.
Hostname Press the Hostname softkey to set the LAN hostname.
Config Mode
Press the Config Mode softkey to select the LAN configuration mode.
–Auto
–Manual
IP Address
Press the IP Address softkey to set the LAN IP address.
This setting is only available when the LAN configuration mode is set to Manual.
Subnet mask
Press the Subnet mask softkey to set the LAN subnet mask address.
This setting is only available when the LAN configuration mode is set to Manual.
Gateway
Press the Gateway softkey to set the LAN gateway address.
This setting is only available when the LAN configuration mode is set to Manual.
DNS 1
Press the DNS 1 softkey to set the LAN DNS 1 address.
This setting is only available when the LAN configuration mode is set to Manual.
DNS 2
Press the DNS 2 softkey to set the LAN DNS 2 address.
This setting is only available when the LAN configuration mode is set to Manual.