Keysight U8903B - Table A-17 Measurement Settings > Phase Menu Tree Description

A Appendixes
506 Keysight U8903B User’s Guide
Phase
Table A-17 Measurement settings > Phase menu tree description
Tab Level 1 Level 2 Level 3 Description
Phase
(Signal Generation)
Waveform
–Sine
– Variable Phase
– Square
– Arbitrary
Select the waveform type.
Output Select the output channel.
Waveform Config Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Waveform Config
Frequency Set the frequency value.
Amplitude Set the amplitude value.
DC Offset Set the DC offset value.
Phase->1st Ch
Set the phase value. This setting is only available
when channel 2 is selected.
Phase
(Signal Analysis)
Ref Channel Set the reference channel number.
Sample Size
– 2048
– 4096
– 8192
– 16384
– 32768
– 65536
– 131072
– 262144
– 524288
–1M
–2M
Select the number of samples to be acquired for
the measurement.
Input Range
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Voltage Range Set the input voltage range.
Phase
Refer to “Bar chart” on page 548 for the bar
chart menu tree.