Keysight U8903B - Appendix 15: HP8903 B Menu Tree; Table A-39 HP8903 B Menu Tree Description

A Appendixes
552 Keysight U8903B User’s Guide
Appendix 15: HP8903B Menu Tree
Table A-39 HP8903B menu tree description
Level 1 Level 2 Level 3 Description
Measurement
Function
–AC LEVEL
–SINAD
– DISTN
–DC LEVEL
– SIG / NOISE
– DISTN LEVEL
Select the HP8903B measurement mode.
LP Filter
–None
– 30 kHz
– 80 kHz
Select the HP8903B measurement low-pass filter value.
HP/W Filter
Select the HP8903B high-pass or weighting filter value.
The filter selection depends on the left and right filters set at HP8903B
Config.
Reference
Set the reference value to be compared with the
measured value in ratio mode.
Changing the reference value will enable the measurement ratio mode.
Ratio
–On
–Off
Enable or disable the HP8903B measurement ratio mode.
Format
–Log
–Lin
Select the HP8903B measurement format type.
Generator
Frequency
Set the HP8903B generator frequency value.
Changing the frequency value will also set the step parameter to frequency.
Amplitude
Set the HP8903B generator amplitude value.
Changing the amplitude value will also set the step parameter to
amplitude.
Step Param
– Frequency
–Amplitude
Select the HP8903B generator step parameter type.
Generator
Freq. Step
Set the HP8903B generator frequency step value.
This setting is only available when the step parameter is set to frequency.
Amp. Step
Set the HP8903B generator amplitude step value.
This setting is only available when the step parameter is set to amplitude.
x 10 Multiply the current parameter step value by 10.
÷ 10 Divide the current parameter step value by 10.
Sweep
Freq. Start Set the HP8903B sweep frequency start value.
Freq. Stop Set the HP8903B sweep frequency stop value.
Sweep Status
–On
–Off
Start or abort sweeping in the HP8903B mode.