Keysight U8903B - Page 427

Appendixes A
Keysight U8903B User’s Guide 427
System
HP8903B Config
Active Channel
–1
–2
Select the HP8903B active channel.
Left Filter
–None
– A-Weighing
– CCIR 1k wtd
– CCIR 2k wtd
– C-Message
– CCITT
– 400 Hz
Select the left filter type.
Right Filter
–None
– A-Weighing
– CCIR 1k wtd
– CCIR 2k wtd
– C-Message
– CCITT
– 400 Hz
Select the right filter value.
Default LPF
–None
– 30 kHz
– 80 kHz
Select the default filter for the HP8903B mode.
Fan & Temperature
Display the temperatures of the available cards
and the speed of the three 80 mm fans in the
U8903B.
Aux Output
Audio Monitor
–On
–Off
Enable or disable the aux audio monitor.
Audio Output
– Speaker
–Phone
Select the aux audio output type.
Audio Mode
–Stereo
–Mono
This is only available when audio output is Phone.
Select the aux audio mode type.
Volume 0 to 100 Select the aux audio volume.
DC Output Set the aux DC output value.
Board Info Display the U8903B available cards information.
Legacy Status
–On
–Off
Enable or disable the legacy sweep.
Macro
(Shift + System)
Reserved for future expansion.
Local
Switch from remote control mode to local mode.
The front panel keys are locked in the remote
mode.
Lock/Unlock
Lock or unlock the front panel keys in the local
mode.
A dialog box will pop-up for confirmation.
Table A-3 SYSTEM panel menu tree description (continued)
Key Level 1 Level 2 Level 3 Description