5Graph Analysis
268 Keysight U8903B User’s Guide
Memory
Figure 5-5 Graph Analysis > Trace Settings > Memory menu page
Table 5-5 Graph Analysis > Trace Settings > Memory menu description
Menu Description
Save To Memory
Press the Save To Memory softkey to save the active trace to the memory buffer
[a]
. The trace in the memory buffer can be
loaded into any other traces. The memory buffer icon will be displayed at the top of the display when there is a trace saved
in the memory buffer as shown in Table 1-5.
Load From Memory
Press the Load From Memory softkey to load a trace from the memory buffer into the active trace. An error will be
displayed if this softkey is pressed when there is no trace in the memory buffer.
Clear Memory Press the Clear Memory softkey to clear the trace from the memory buffer.
[a] Files saved in the internal volatile memory will be erased after power cycle or reset (refer to “Preset” on page 78).
To Next Page
Loading...
