Keysight U8903B - Page 311

Test Sequence Application 7
Keysight U8903B User’s Guide 311
Settings
Press the Settings softkey to configure the selected measurement. Refer to the respective measurement settings for more
information.
– AC level
– Frequency
– Phase
– SNR
– THD+N
– DC level
– Crosstalk
– SMPTE IMD
– DFD IMD
– Multitone analyzer
– Stepped frequency sweep
– SMPTE frequency sweep
– DFD frequency sweep
– Stepped level sweep
– SMPTE level sweep
– DFD level sweep
– DC level sweep
– Receiver sensitivity
– Measurement recorder
– Voice quality
Properties
Press the Properties softkey to configure the measurement properties. Refer to “Properties” on page 312 for more
information.
Table 7-14 TSA > Project > Test > Measurement menu description (continued)
Menu Description