A Appendixes
496 Keysight U8903B User’s Guide
Test
Enable
–On
–Off
Enable or disable the selected test sequence.
Add Test Sequence
New
Saved
Add a new test sequence.
Delete Test Sequence Delete the selected test sequence.
Save
Save the test sequence to a file.
Refer to “Append ix 12: Save Menu Tree” on
page 493 for the save menu tree.
Edit
Move Move the selected test sequence.
Copy Copy the selected test sequence.
Paste
Paste a copied test sequence after the selected
test sequence.
Properties Name Set the test sequence name.
IO Configuration
Add Measurement
Add measurements to the selected test sequence.
Refer to “Add Measurement” on page 500 for
the list of test measurements.
Edit Paste
Paste a copied measurement after the IO
configuration. The IO Configuration cannot be
moved or copied.
Settings: Output
Configuration (Analog)
Channels
– None (External)
–1
–2
Select the number of output channels in use.
Connector
–Bal
–UnBal
–Com
– IEC60268
Select the output connector type.
Impedance
– For Bal, Com, and
IEC60268
– 600 Ω
– 100 Ω
–40 Ω
–For UnBal
– 600 Ω
–50 Ω
–20 Ω
Select the output impedance value.
IEC60268
–Pin 2
–Pin 3
Select the additional 10 Ω output series
resistance for pin 2 or 3 of the XLR connector in
the common IEC 60268 configuration.
This setting is only available when the output
connector type is set to IEC 60268.
Ground
–Float
– Ground
Select the grounding type.
Table A-14 Test sequence menu tree description (continued)
Tab Level 1 Level 2 Level 3 Description
To Next Page
Loading...
