Keysight U8903B - Page 502

A Appendixes
502 Keysight U8903B User’s Guide
Measurement Properties
Sub-Steps:
Prompt
Properties Set the prompt sub-step name.
Sub-Steps:
Send SCPI
Enable Enable or disable the send SCPI sub-step.
Add Sub-Step
Add sub-step to the list.
– Delay
–Prompt
– Sent SCPI
Delete Sub-Step Delete the selected sub-step.
Edit
Move or copy the selected sub-step, or paste a
copied sub-step after the selected sub-step.
Settings
– GPIB Address
Select the desired GPIB address.
– SCPI Commands
–Edit
Set the SCPI commands at the lower half of
the main display.
–Import
Load the SCPI commands from a file. Refer
to “Appendix 13: Recall Menu Tree” on
page 494 for the recall menu tree.
– Progress Msg
Set the optional text message that will be
displayed on a dialog box for the time length
set in Delay.
– Delay
Set the delay time length after the SCPI
command(s) is executed.
Properties Set the prompt sub-step name.
Failure Handling
–Cancel Seq.
– Allow Retry
– Continue Seq.
Select the failure handling type for the selected
measurement.
Table A-14 Test sequence menu tree description (continued)
Tab Level 1 Level 2 Level 3 Description