Keysight U8903B - Page 542

A Appendixes
542 Keysight U8903B User’s Guide
Stepped Level Sweep
(Signal Analysis)
Notch Filter
HP8903B
–On
–Off
Enable or disable the HP8903B mode.
Custom Notch
–On
–Off
Enable or disable the custom notch.
Center Freq
Set the center frequency value. This is only
applicable when custom notch is enabled.
Bandwidth
Set the bandwidth value. This is only applicable
when custom notch is enabled.
Sample Size
– 2048
– 4096
– 8192
– 16384
– 32768
– 65536
– 131072
– 262144
– 524288
–1M
–2M
Select the number of samples to be acquired for
the measurement.
Input Range
Auto Range
–On
–Off
Enable or disable the auto input range.
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Voltage Range Set the input voltage range.
–AC Level
–Gain
– THD Ratio
– THD Level
– THD Ratio Vs Measured Amplitude
– THD Level Vs Measured Amplitude
– THD+N ratio
– THD+N Level
– THD+N Ratio Vs Measured Amplitude
– THD+N Level Vs Measured Amplitude
–SINAD
Refer to “Graph” on page 549 for the graph
menu tree.
Table A-34 Measurement settings > External Level Sweep menu tree description (continued)
Tab Level 1 Level 2 Level 3 Description