Keysight U8903B - Page 361

Test Sequence Application 7
Keysight U8903B User’s Guide 361
HPF
Press the HPF softkey to select the high-pass filter.
–None
–15 Hz
–20 Hz
–22 Hz
–30 Hz
–50 Hz
–70 Hz
– 100 Hz
– 200 Hz
– 300 Hz
– 400 Hz
– Custom
Weighting
Press the Weighting softkey to select the weighting filter.
–None
–A
– CCIR 1k
– CCIR 2k
–CCITT
– C-Message
– Custom
Deemphasis
Press the Deemphasis softkey to select the de-emphasis filter.
–None
–50 μs
–75 μs
– Custom
Notch Filter
Press the Notch Filter softkey to configure the notch filter settings.
– HP8903B
Enable or disable the HP8903B mode.
– Custom Notch
Enable or disable the custom notch.
– Center Freq
Set the center frequency value. This is only applicable when custom notch is enabled.
– Bandwidth
Set the bandwidth value. This is only applicable when custom notch is enabled.
Table 7-43 External Frequency Sweep > Signal Analysis settings menu description (continued)
Menu Description