Keysight U8903B - Page 383

Test Sequence Application 7
Keysight U8903B User’s Guide 383
Freq Lock
Press the Freq Lock softkey to select the searching method for the fundamental frequency.
–Auto
Selecting Auto will allow the U8903B to search for the fundamental frequency automatically.
– Custom
If you have a known input signal, you can define the fundamental frequency value by setting the searching method to
Custom and setting the frequency value in Fund Freq.
Fund Freq
Press the Fund Freq softkey to set the fundamental frequency value. This setting is only available when Freq Lock is set to
Custom.
LPF
Press the LPF softkey to select the low-pass filter.
–None
–2 kHz
–3 kHz
–5 kHz
–8 kHz
–10 kHz
–15 kHz
–20 kHz
–22 kHz
–30 kHz
–40 kHz
–50 kHz
–80 kHz
– Custom
HPF
Press the HPF softkey to select the high-pass filter.
–None
–15 Hz
–20 Hz
–22 Hz
–30 Hz
–50 Hz
–70 Hz
– 100 Hz
– 200 Hz
– 300 Hz
– 400 Hz
– Custom
Weighting
Press the Weighting softkey to select the weighting filter.
–None
–A
– CCIR 1k
– CCIR 2k
–CCITT
– C-Message
– Custom
Table 7-53 Receiver Sensitivity > Signal Analysis settings menu description (continued)
Menu Description