Keysight U8903B - Page 402

7 Test Sequence Application
402 Keysight U8903B User’s Guide
Graph Properties
Press the Graph Properties softkey to set the graph properties.
– Title
Edit the graph title.
–X-axis
–Auto Scale
Enable or disable the X-axis autoscale.
–Spacing
Select Linear or Log for the spacing.
–Unit
Select the X-axis unit type.
–Left
Set the X-axis left edge value. This setting is only available when Auto Scale is disabled.
–Right
Set the X-axis right edge value. This setting is only available when Auto Scale is disabled.
–Center
Set the X-axis center value. This setting is only available when Auto Scale is disabled.
–Span
Set the X-axis span value. This setting is only available when Auto Scale is disabled.
–Y-axis
–Auto Scale
Enable or disable the Y-axis autoscale.
–Spacing
Select Linear or Log for the spacing.
–Unit
Select the Y-axis unit type.
–Top
Set the Y-axis top value. This setting is only available when Auto Scale is disabled.
–Bottom
Set the Y-axis bottom value. This setting is only available when Auto Scale is disabled.
–Traces
–Trace
Select the analyzer trace channel.
– State
Enable or disable the trace.
– Color
Set the trace color.
Graph Properties
(This is only applicable for
POLQA measurement
MOS-LQO and Delay
results)
Press the Graph Properties softkey to set the graph properties.
– Title
Set the bar chart title.
–Auto Scale
Enable or disable autoscale.
–Left
Set the X-axis left edge value. This setting is only available when Auto Scale is disabled.
–Right
Set the X-axis right edge value. This setting is only available when Auto Scale is disabled.
–Top
Set the Y-axis top edge value. This setting is only available when Auto Scale is disabled.
–Bottom
Set the Y-axis bottom edge value. This setting is only available when Auto Scale
is disabled.
Table 7-60 TSA > Project > Test > Measurement > Settings > Result (graph) menu description (continued)
Menu Description