2-102 Service Manual
4062
931.00 No first laser H sync The hsync signal is missing or
not at the correct voltage.
1. Check all connections on
the printhead assembly for
proper connectivity.
2. Check all connections on
the system card assembly
for proper connectivity.
3. Check all printhead
connections for possible
damage and poor
continuity.
4. Replace the system card
assembly. Go to “System
card assembly removal”
on page 4-75.
5. Replace the printhead
assembly. Go to
“Printhead assembly
removal (T650)” on
page 4-59 or “Printhead
assembly removal (T652,
T654, T656)” on
page 4-60.
932.00 Printhead lost laser H
syncs.
The hsync signal is missing or
not at the correct voltage.
Replace the printhead
assembly. Go to “Printhead
assembly removal (T650)” on
page 4-59 or “Printhead
assembly removal (T652,
T654, T656)” on page 4-60.
933.00 Polygon mirror motor
locked. No first laser
H sync received.
The hsync signal is missing or
not at the correct voltage.
Replace the printhead
assembly. Go to “Printhead
assembly removal (T650)” on
page 4-59 or “Printhead
assembly removal (T652,
T654, T656)” on page 4-60.
934.00 Mirror motor lost lock. The signals driving the polygon
motor may have been
corrupted, or the cable may be
loose, or the motor may be
bad.
1. Check all connections on
the printhead assembly.
2. Check all connections on
the system card assembly.
3. Replace the printhead
assembly. Go to
“Printhead assembly
removal (T650)” on
page 4-59 or “Printhead
assembly removal (T652,
T654, T656)” on
page 4-60.
935.00 Polygon mirror motor
control failure.
The signals driving the polygon
mirror motor may have been
corrupted, or the cable may be
loose, or the motor may be
bad.
1. Check all connections on
the printhead assembly.
2. Check all connections on
the system card assembly.
3. Replace the printhead
assembly. Go to
“Printhead assembly
removal (T650)” on
page 4-59 or “Printhead
assembly removal (T652,
T654, T656)” on
page 4-60.
Error
code or
message
Error contents Description/Action Possible repair actions