2-8 Service Manual
4062
44.36 RFID Error Invalid X/Y Position 1. This error code most likely
indicates a problem with
the customer’s datastream,
and not the RFID Option
itself. Ensure there is
nothing wrong with the
customer’s datastream.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to
“Installing / Removing
the RFID UHF option” on
page 4-149.
3. Replace the RFID UHF
option.
42.XY Cartridge Region
Mismatch
This IR is displayed when the
printer detects that the installed
cartridge has a region that
differs from the below options.
To clear this IR, the printer
cartridge must be replaced with
one that has a proper region.
X and Y can have the following
values:
0 : Worldwide region or
Undefined region
1 : America
2 : EMEA
3 : Asia
4 : Latin America
9 : Invalid region
Install a new toner cartridge
that matches the correct
regional specification.
50 PPDS Font Error This message displays when
the PPDS interpreter has
encountered a font error.
Note: This error may only
occur when the printer is
formatting PPDS print data.
The following actions may be
taken:
• Press to clear the
message and continue
processing the job.
• Press until Busy/
Waiting appears. The
following are available:
-Cancel Job
- Reset Printer
- Reset Active Bin
51 Defective Flash This message displays when
the printer detects a defective
flash. This error may occur at
power on, or during flash
format and write operations.
Press to clear the
message. The flash is marked
as bad and normal operation
continues. Flash operations
are not allowed until the
problem is resolved.
Error
code or
message
Error contents Description/Action Possible repair actions
To Next Page
Loading...
Need help?
General
