Lucent Technologies 5ESS - Page 489

SW:QLPS=0-d;
If the switch is successful, obtain the QPIPE status:
OP:STATUS,GQPHQPIPE,QPIPE=a-b-c-d-e;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
If the resultant state is
OOS-QLPSLB or OOS-LVL1-FRAME,
CONTINUE this procedure for further recovery.
Otherwise, RETURN to Step 1 because the status of multiple GQPH
QPipes may have been affected by hardware reconfigurations.
............................................................................................................................................................
9
In a further attempt to isolate undetected problems in parent CM
hardware, attempt to conditionally restore each GSM primary NLI in
target network
d.
OP:STATUS,GQPHQPIPE,QPIPE=a-b-c-d-e,DETAIL;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = GQPH channel group number
e = QLPS network number
The corresponding primary NLI serving the ACT QLPS on QLPS
network
d is specified in the output. Only a single digit j (0 or 1) is
specified and actually
NLI a-j-k, where k is the ONTC side could
serve GQPH QPipe on the target QLPS network.
RST:NLI=a-j-k;
If the conditional restore fails, then refer to the Corrective
Maintenance procedure, Clear Network Link Interface Problems,
235-105-220, to repair the NLI.
Resolve GQPH QPipe Problems
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-53