106
If you set a date, the PIN code is valid starting from this point in time.
If you leave the field blank, the PIN code is immediately valid.
Expiry date
You can set a date in the form 22/09/2016 08:00. After this set date/time, the PIN
code is no longer valid. If you leave the field blank, the validity of the code is
unlimited.
Arm/disarm
This option serves to set the authorization to arm or disarm the alarm panel with
the respective PIN code.
Report
Is this option enabled, you are informed via contact ID, e-mail, and text message
whenever the respective PIN code is used. It is necessary to also set-up this
notification in the report menu.
Delete
Deletes the respective PIN code. To apply changes, click “OK” at the bottom of
the page. If you want to neglect the last changes, click “Reset.”
Special codes area 1 /2
Use the “Special codes” menu of the alarm panel to enter various additionally special
codes that can be used with the keypad.
Code for silent alarm
If you are forced to enter a code, you can enter the silent alarm code instead of
your standard PIN code. This will stop the acoustic alarm – if active – and sends
out a silent “personal threat” alarm via all active notification methods.
Code for guard service (CMS)
Enter a code for the security firm. This code would allow an employee of the
security firm to arm/disarm the alarm panel via your keypad.
Temporary code
This code is only once valid and disarms or arms the alarm panel (or sets it to a
home mode). If you arm the alarm panel or set it to home mode by means of this
code, the temporary code is deleted. When disarming, the code is not deleted from
the list, but cannot be used again for disarming. Check the “Report” option if you
want to be notified via contact ID in case this code is used.
To Next Page
Loading...