264
Connecting the remote control V2 and putting it into operation
1. Use a coin to open the battery compartment.
2. Install the battery with the negative pole facing down (the flat, positive pole
faces up).
3. Close the battery compartment again.
4. Open the main menu of the alarm panel.
5. Open the menu “Sensors” “Add”.
6. Press “Start”.
7. Press any button of the remote control for approx. three seconds.
8. The alarm panel will confirm the successful addition with a brief signal tone
and display the remote control in the menu “Sensors” “Add”. Click on next
to the sensor to finish the connection process.
Range test:
1. Open the alarm panel menu “Sensors” “Range” and press “Start”.
2. Press the learn button.
3. The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
You can add the remote control to area 1 or 2. The remote control can only control
the area to which it was added.
You can edit the settings of the remote control by assigning each button a pre-
defined command. Thus, you can also set the remote control to switch to home
mode 2 or 3. A in detail description for the different automation rules can be found
in the chapter on Smarthome in the XT manual.
If you have triggered any kind of alarm via the remote control, it is not possible to
deactivate this alarm with the remote control!
The remote control V2 uses a rolling code encryption.
To Next Page
Loading...