254
Radiator valve thermostat V2
Attention:
This product is not compatible with the “XT1” or the XT2 without an additional
“upgrade dongle to XT2 Plus!”
Before you install the radiator valve thermostat, clean and lubricate the heater
valve. Tight or rusty valves may damage the radiator valve thermostat beyond
repair.
Product description:
The radiator valve thermostat V2 serves to control the room temperature in your home.
Regardless of where you are, the free LUPUS app allows you to set the temperature to
your individual requirements. Of course, you can also set the temperature via the web
interface and control the radiator valve thermostat manually. You can also automate and
control the temperature at specific times or events. The radiator valve thermostat is
installed within a few minutes at all customary heaters.
1. Fastening screw thread
Standard size M30 x 1.5. is required to mount the radiator
valve thermostat to the heater/valve. Thread adapters for
other sizes are available in the LUPUS web shop.
2. LCD display
A. Lights up if the devices has already been added.
B. Low battery
If it is required to replace the battery, the alarm panel and the
radiator valve thermostat will inform you by means of the
battery symbol.
C. Lights up if the radiator valve thermostat was adjusted
manually to 17°C night temperature.
Lights up if the if the radiator valve thermostat was
adjusted manually to 21 °C day temperature.
Flashes: valve is opened further and the room
temperature rises.
Note:
Both values are fixed pre-set and cannot be changed.
D. Auto / Manual mode
The automatic mode is only available if the radiator valve
thermostat was added to an alarm panel.
To Next Page
Loading...