153
Integration of lamps of other manufacturers
You can connect Smarthome lamps of other manufacturers to your alarm panel. We
tested lamps of Philips Hue, Osram Lightify, Innr, IKEA; and Paulmann with our alarm
panels.
Requirements:
XT1 Plus, XT2 Plus, or XT3 (firmware 0.0.2.18 or above).
A ZigBee lamp of one of the above mentioned manufacturers. If the lamp is
already connected to a gateway of the manufacturer, you also need a remote
control of the manufacturer in order to reset the lamp. Please contact the
manufacturer of your lamp for further information.
Single, not yet connected lamps, send a learn signal when they are installed
(switched on).
When using products from other manufacturers that are not produced or sold
by LUPUS-Electronics GmbH, LUPUS-Electronics GmbH does not grant any
warranty and is not liable. The LUPUS-Electronics GmbH refuses any
warranty, liability, compensations, or other responsibility for damages that
result (direct or indirect) from using products of other manufacturers in
combination with one of our products.
Example: Reset of a Philips hue lamp:
Hold the remote control of the Philips Hue lamp directly to the lamp and follow the
instructions.
A. Philips Hue dimmer remote control:
Hold ON (I) and Off (o) until your Hue lamp flashes
three times (approx. 5 seconds). Release the two
buttons.
B. Living colours remote control
Hold ON (I) and Scene 1 (favourite 1) until
your living colours lamp flashes three times
(approx. 4 seconds).
To Next Page
Loading...