319
Water sensor V2
Attention:
This product is not compatible with the XT1 or XT2 without “Upgrade dongle to XT2
Plus.”
Product description:
The water sensor allows you to be alarmed about imminent flooding and to react in time.
If the probe detects water for more than ten seconds, the water sensor sends an alarm
signal to the alarm panel and both emit acoustic alarms.
Sensor data:
Dimensions (without mount): 9.5 x 3 x 8.3 cm (3.74 x
1.18 x 3.26 inches)
Cable length: 29.5 cm (11.61 inches)
Weight: 113 grams (0.24 lbs)
Operating temperature: -10°C to 45°C (14F to
113F)
Humidity: Maximum 85%
Detection method: Wheatstone measuring
bridge
1. Red LED (internal)
Flashes twice: water detector was
successfully added
Flashes every twenty minutes: water
detector has lost the connection
Flashes permanently: water detector is in
standby mode
2. Learn/Test button
Pressing the button once sends a supervisor
signal to the alarm panel.
Pressing the Test button for more than ten
seconds resets the water detector and
deletes it from the sensor list.
Pressing the Test button while the water
detector emits an alarm sets the water detector to standby mode.
3. External water probe
4. External water probe port
5. Battery compartment
The water sensor required a CR123 A 3 V lithium battery. The average
battery life is 2.6 years, if one alarm per month is triggered.
The water detector sends a status message to the alarm panel every 30
minutes or when the Test button is pressed. The alarm panel is informed
immediately when the battery runs low.
6. Attachment notches for wall mounting
7. Water sensor on housing bottom
To Next Page
Loading...