318
Range test:
1. Open the alarm panel menu “Sensors” “Range” and press “Start”.
2. Press the test button.
3. The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advice to use a
repeater, since it is normal that the signal strength may fluctuate for 2-3 points,
thus, a signal loss is possible.
Batteries:
The water detector requires four alkaline batteries. The average battery life is approx. 3
years. The water detector sends the status to the alarm panel every 30 to 50 minutes. If
the battery runs low, this is reported to the alarm panel immediately.
Installation:
1. Remove the screw from the bottom of the housing.
2. Drill through the two cavities left for the screws, if you want e.g. to install the
water sensor to the wall.
3. Install the water sensor at your chosen location.
4. Place the water detector, which is at the end of the cable, on the location,
where it is intended to trigger water alarm, e.g. on the floor. If water forms a
bridge between the two pins, it triggers an alarm. Fix the sensor so that it
cannot accidentally shift.
5. Close the housing and fix it with the screws.
Please note:
In case of water contact, the water detector sends an alarm to the alarm panel twice at a
two-minute interval. If the contact continuous to be bridged, the water sensors sends out
one alarm per hour. If the water level falls again, the water detector returns to its normal
mode.
To Next Page
Loading...