14
Putting the LUPUSEC-XT2 (Plus) into operation
The following pages describe the installation and start-up of the alarm panel
systematically. To avoid damages to the system, please observe these instructions in
detail and read the manual carefully before you start.
Remove the alarm panel from the packaging. Please check immediately after the delivery
for possible transportation damages and whether the product’s scope of delivery. In case
of damages or missing items, contact your retailer immediately.
WARNING
When in doubt do not assemble, install, and wire the alarm panel by
yourself, but hire a specialized electrician. Improper and unprofessional
execution of works at the power supply system pose a danger to you and
other persons.
Place of installation
The place of installation is crucial for the smooth operation of the system, as all sensors
are connected to the alarm panel wirelessly (868 MHz or 2.4 GHz). Therefore, the alarm
panel should be installed at a central location, in order to ensure the shortest possible
transmission distances to all sensors, as well as, an Ethernet connection to your router
or switch. The wireless transmission range of the alarm panel can be enhanced by using
a wireless repeater. When choosing the place of installation, please note the “important
safety information” above.
Important
The XT2 (Plus) is not equipped with a tampering contact. We advice you to use a
motion detector to trigger an instant alarm if anyone approaches the alarm panel while it
is in arm mode.
The XT1 Plus and XT3 are equipped with a tampering protection, nevertheless, we
would also advise you to follow the same security arrangements as with a XT2 (Plus).
To Next Page
Loading...