227
Medical emergency controller
Product description:
Dimensions (LxWxH): 38.6 x 25 x 10.9 cm (15.19 x 9.84 x 4.29 inches)
Weight: Sensor: 8 gram (0.01 lbs), Strap: 18 gram (0.03 lbs)
Place of installation: Mobile: Wristband or necklace
Operating temperature: -10 °C to +50 °C (14F to 122F)
Humidity: Maximum 85% (non-condensing)
Water resistance: Splash water resistant
Radio frequency: 869.2375 MHz
Detection method: Mechanical (by pressing of the alarm button)
Alarm button:
If the alarm button is pressed for more than one
second, an alarm of the alarm panel is triggered.
If this button is pressed for more than eight seconds
during the alarm, the alarm is deactivated.
The LED lights up as a confirmation.
Connecting the medical emergency controller and putting it into
operation
1. Open the configuration page of the alarm panel, open the menu “Sensors”
“Add”, and press “Start”.
2. Press the alarm button of the medical emergency controller.
3. The configuration page of the alarm panel should list the medical emergency
controller.
4. Add the medical emergency controller.
Range test:
1. Open the alarm panel menu “Sensors” “Range” and press “Start.”
2. Press the alarm button of the sensor.
3. The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advice to use a wireless
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
To Next Page
Loading...