324
Wireless repeater V2
You can connect only a limited number of sensors to the XT alarm panel. If the range of
one or more sensors is insufficient, you can increase the range with the wireless repeater
V2. The wireless repeater V2 allows you to nearly double the transmission range,
because the sensors are sending their signals first to the repeater and then the repeater
relays these signals to the alarm panel.
The repeater works on the 868.6625 MHz frequency and can amplify only sensors within
this frequency range. The repeater does not support ZigBee devices.
1. Power LED (green)
On = operating
Off = Off
Flashing = low battery
2. Mode LED (yellow)
On = the repeater is in learn mode
Flashing = the wireless repeater V2 is in range test mode
3. Receiver LED
This LED flashes when the wireless repeater V2 receives a signal from the alarm
panel.
4. Transmission LED
This LED flashes when the wireless repeater V2 transmits a signal to the alarm
panel.
5. Learn button (alarm panel)
6. Connection-test button
7. Learn button (sensor)
To Next Page
Loading...