Lupus Electronics XT 1 Plus - Defining Automation Actions; Action Configuration Options

65
To use the following schedules sunrise, sunset, and daytime you need to select a
city or your longitude and longitude in the menu “Settings”  “Date & Time”.
 Sunrise
This option allows you to execute a home automation at sunrise. Furthermore, you
can set a time in minutes to execute the automation e.g. 30 minutes before sunrise.
To use this option, you need to specify your degree of latitude and longitude in the
menu “Settings”  “Panel”  “Date and Time.”
 Sunset
Identical to sunrise for a schedule at sunset.
 Daytime
The options allows you to execute a rule only during the day or during the night.
Similar to the “sunrise” and “sunset” schedule, you need to define you exact
location in the menu “Setting”  “Date and Time”. Day is between sunrise and
sunset, night is between sunset and sunrise.
Action
 None
If this is selected, no action is performed. This is only a placeholder for the creation
of an automation rule – you need to define an action.
 Mode
This action allows you to change the alarm mode of your alarm panel. You can
define which area you want to change and into which mode you want to switch.
Please note, the normal rules for mode switching still apply (e.g. it is not possible
to switch to home mode while the alarm panel is in arm mode).
 Apply scenario
This action allows you to perform a scenario.
 Switch setup (only wireless plugs and relays)
First, use the drop-down menu to select the switch you want to control
o Turn on: The selected switch is switched on (e.g. to supply connected
devices with electric power).
o Turn off: The selected switch is switched off (e.g. the connected devices are
no longer supplied with electric power).
o Toggle: The selected switch is switched to the opposed state (e.g. on  off;
off  on).
o Duration (only available for turn on): You can select if the device should be
switched on continuously. If you select a time instead, the switch is switched
off again after the selected time.
 Lamp setup (only for Smarthome color lights)
The available settings are identical to switch setup. Additionally, you have settings
for dimming (0% - 100% in 10% steps) and color (if these settings are supported
by your lamp). This automation allows you to control your Smarthome lamp
directly, to dim it, switch it on or off, and to change the color of the light.