303
Connecting the temperature sensor with external probe and putting it into operation
1. Open the housing and insert the batteries into the battery compartment.
2. You can add the temperature sensor with external probe to the alarm panel only
within the first three minutes after having inserted the battery!
3. Open the menu “Sensors” “Add” and press “Start” in the web interface of the
alarm panel.
4. Press the learn button for approx. ten seconds.
5. If the alarm panel recognizes the temperature sensor, the LED briefly flashes twice.
6. As soon as the alarm panel has received the connection request, the sensor list
shows the sensor. Press to add the temperature sensor to the alarm panel.
Assign an optional name.
Range test:
1. Open the alarm panel menu “Sensors” “Range” and press “Start”.
2. Press the learn button.
3. The sensor and the signal strength should be indicated. The higher the indicated
number the better the reception (1-9).
Please note:
If the signal strength at the place of installation is below 4, we advise to use a ZigBee
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Note:
The current temperature is displayed in the menu “Sensors” “List” “Status”.
In the menu “Smarthome” “Temp. History”, the temperature of the last hours,
days, and weeks is displayed.
The temperature sensor is not compatible with the wireless repeater and cannot
be saved in the backup file.
The signal of the temperature sensor can be enhanced by a ZigBee repeater.
The external probe can detect temperatures between -35°C to 65°C (-31F to
149F).
To Next Page
Loading...