Lupus Electronics XT 1 Plus - Relay with Power Meter V2 Installation

260
Relay with power meter V2
CAUTION:
Only certified electricians or persons instructed in electrical engineering with
knowledge and understanding of electric current and the inherent risks are
allowed to execute the installation.
Attention:
This product is not compatible with the “XT1” or the XT2 without an additional
“upgrade dongle to XT2 Plus!”
Technical data:
Dimensions
approx. 52 x 49 x 25mm (WxHxD)
Weight
approx. 40 Gramm
Tampering protection
-
Status display
Yes, red LED at the front
Status checked and displayed in the alarm
panel
Yes
Radio frequency
2.4Ghz ZigBee S
Radio performance
max. 10mW
Transmission range
approx. 30 to 100m (32 to 109 yards)
depending on the local conditions)
Modulation
FM (SRD Category 2)
Switching Capacity / Current Consumption
max. 3680W 16A
Load type
ohmic load
Power consumption in standby
0,6 W
Relay
Closing contact, 1-pole, µ-contact
Switching cycle
40000 (16A, ohmic load)
Duty-Cycle
< 1 % pro h
Degree of protection
IP20
Protection class
II
Degree of contamination
2
Power supply
230V / 50 Hz
Conforms to the following standards
CE, FCC, RoHS
Working environment
5°C to 35°C (41F to 95F), max. 85% (non-
condensing)