11
Important safety information
WARNING
The warranty claim will expire in case of damages resulting from the
non-observance of this manual.
We do not assume any liability for consequential damages.
We do not assume any liability for damages to persons and/or
material whatsoever, which result from improper handling or
noncompliance with the safety instructions. The warranty claim will
expire in such cases!
This alarm panel is equipped with a high-quality housing. However, please observe the
following safety regulations:
Handle the alarm panel with care, heavy vibration or bumps may damage this alarm
system.
Never open the alarm panel’s housing! This is dangerous and your warranty will expire
immediately.
Connect the alarm panel only to the approved and intended voltage. Operate the alarm
system only with the provided mains adapter. XT2 (Plus) and XT3 12V DC – 2 ampere.
XT1 Plus 9V DC – 1 ampere.
The socket must be located in an easily accessible, moisture-proof indoor location.
Do not expose the alarm panel to direct sunlight or strong heat, e.g. heaters.
Provide for sufficient ventilation of the system. Keep a minimum safety distance of 10
cm (4 inch) to all sides.
Do not install the alarm panel close to strong electric power lines or magnetic fields, as
this may impair the transmission quality significantly.
Do not install the alarm panel directly on iron or aluminum surfaces without isolating
the foot of the alarm panel from the floor, as this may impair the wireless transmission
significantly.
Do not install the alarm panel in moist, very cold, or very hot environments. Please
observe the maximum humidity and temperature limits (-10°C to +45°C (50F to 113F),
maximum 90 % relative humidity).
Do not expose the alarm panel to strong temperature changes. This could result in
short-circuits due to condensation.
The alarm panel may not get in contact with liquids of any kind.
Persons (including children) with limited physical, sensory, or mental abilities and/or
lacking experience and/or knowledge must not use this product.
Keep children away from the product and other connected electrical appliances at all
times. The alarm panel includes cables, which can strangle children, and small parts
they can swallow. Lay cables expertly so that they are neither bent nor otherwise
damaged. Assemble the alarm panel out of children’s reach. Do not leave packaging
materials unattended, as they may be dangerous for playing children.
Use a damp cloth to clean the alarm panel’s surface. Afterwards, dry the surface.
Cleaning agents will damage the surface.
To Next Page
Loading...