46
Sensors
This menu shows the sensor list including all the connected sensors. The submenu “Add”
allows you to integrate new sensors to the alarm panel; “Range” is used to test the signal
strength; “Universal remote control” allows you to set-up your “universal IR controller”.
Note:
All components except wireless relays (item no 12014) and repeaters (item no 12016)
are counted as sensors. The alarm panel features two areas and each area supports up
to 80 sensors. Of the 160 sensors that could be connected, only 40 may be ZigBee
devices and 6 may be “PIR network cameras”. By using a ZigBee repeater you can
enhance the maximal amount of ZigBee devices that you can connect to the alarm panel
(depending on the repeater between 10 and 40 additional ZigBee devices are possible).
The maximal amount of possible sensors (80 per area) is not increased when using a
ZigBee repeater
Additionally, you can connect any number of devices (“wireless relay” item no. 12014 and
“wireless repeater” item no. 12016).
To Next Page
Loading...