250
PIR network camera V3
Product description
Attention:
This product is not compatible with the XT1 or the XT2 (without the “Upgrade Dongle to XT2
Plus”).
Product description:
The PIR network camera is a motion detector with an integrated
mini snapshot camera. When the RAS (Infrared Reflection
Absorption Spectroscopy) sensor detects a motion, images will be
taken immediately and send to your alarm panel. Of course, the
PIR network camera will also trigger an alarm. Even in darkness, the
IR-LED of the camera guarantees that you will receive brilliant
images. Thus, you are not only alarmed that movements took
place, you are also able to check who or what was moving. The
PIR network camera is battery powered and connects wirelessly to
your XT alarm panel. The PIR network camera V3 can also be
triggered by pets.
1. IR-LED
2. Learn button / blue LED
3. Infrared sensor
4. Lens
5. Cover of the battery compartment
6. Tampering contact
7. Battery compartment
8. Sensitivity Jumper (JP3)
9. Standby mode ON/OFF jumper (JP2)
Blue LED:
The LED (4) flashes every 20 seconds when the network
camera is not connected to the alarm panel.
The LED flashes three times in case of motion detection
when the system is armed.
The LED flashes once in case of motion detection in test
mode.
If the LED is constantly on, the camera is defect.
Batteries:
The PIR network camera V3 requires three CR123 lithium batteries. The average battery
life is approx. 1.5 years. The alarm panel will inform you in case of a battery running low.
To Next Page
Loading...