Lupus Electronics XT 1 Plus - Home Automation Settings Explained; Setting Automation Conditions

62
Home Automation settings
In the following, we explain the various options of the home automation menu in detail.
In order to create a home automation, you need to insert the following information:
 Condition – if the condition is met, the home automation is executed.
 Schedule – the home automation is only executed if the condition is met at the
defined time.
 Action – the home automation action you want to execute when a certain condition
is met at a certain time.
Condition
 Schedule
If you select “schedule”, there is no requirement for this automation other than the
set time in the schedule.
 When the alarm is activated
This condition allows you to execute a home automation when an alarm is
triggered. You need to define if the alarm has to be triggered in area 1 or area 2
and if the automation is executed only in case of a certain alarm or in case of all
alarms in the selected area.
 Triggered sensor action
This condition allows you to execute a home automation when a sensor sends a
status change. In order to use this condition, you need to define, in the settings of
the sensor (“Sensors”  “List”  “Sensor List”  ), that the sensor has to “apply
rule X” in case of a status change. If the sensor sends a status change, the rule X
is applied as well. Additionally, you can define if this rule shall always be applied
or only if the alarm panel is in a certain mode.
 Entering delay
This condition allows you to execute a home automation when the entering delay
begins. Additionally, you can define the area and mode of the entering delay.
 Leaving delay
This condition allows you to execute a home automation when the leaving delay
begins (when you arm the alarm panel). Additionally, you can define the area and
mode of the leaving delay.
 Mode
This condition allows you to execute a home automation if the mode of the alarm
panel is changed. If you select “mode area 1 disarm,” the automation is always
performed when area 1 is switched to disarm.
 Temperature between
This condition allows you to specify two values for a certain temperature sensor. If
the temperature is between these values, the home automation is executed.
 Temperature above
This condition requires you to select a temperature sensor. If the temperature rises
above the set value, the home automation is executed.
 Temperature below
Identical to “temperature above”, however, the home automation is executed when
the temperature is below the set value.
 Energy above
This condition allows you to define a wireless power supply device or relay with