Lupus Electronics XT 1 Plus - Page 63

63
power meter and to execute a home automation if the power consumption of this
device is above the set value.
 Energy below
Identical to “energy above”, however, the home automation is executed when the
energy consumption is below the set value.
 Humidity above
This condition is identical to “temperature above,” however, the home automation
is executed if the humidity is above the set value.
 Humidity below
This condition is identical to “temperature below,” however, the home automation
is executed if the humidity is below the set value.
 Door Lock
You can use your connected Nuki lock to trigger an automation when the door is
“locked” or “unlocked”. If you connect additional conditions via “and” to this
condition, you can define that a automation is only performed when your door is
“locked” or “unlocked”.
(To connect a Nuki lock, please go to chapter “Settings”  “Device integration” 
“Nuki”).
 Lux between
This condition allows you to select a light sensor and to set two lux values. If the
lux value is in between the two specified values, the home automation is executed.
Please refer to the light sensor’s manual for an in detail breakdown of the lux
values.
 Lux above
This condition is identical to “temperature above,” however, the home automation
is executed if the lux value is above the set value.
 Lux below
This condition is identical to “temperature below,” however, the home automation
is executed if the lux value is below the set value.
 Fritz!Box phone call
This condition allows you to use your Fritz!Box as a trigger for a home automation.
To use this function, you need to insert the host IP and port of your Fritz!Box in the
menu “Settings”  “Device integration”  “Fritz!Box”.
 Open since
You can assign a span of time to a door contact. If this door contact is open for the
set time, the action is performed.
 No motion since
You can assign a span of time to a motion detector. If during the set span of time,
no motion is detected, the action is performed.
 Switch
This condition depends upon the status of a selected wireless plug or relay. If the
selected wireless plug or relay is switched “on” or “off”, the condition is met and
the rule will be executed. If you combine multiple conditions, the current status of
the selected wireless plug or relay (“on” or “off”) is monitored.
 Doorcontact
This condition depends upon the status of a door contact. If the selected door
contact is opened or closed, the condition is met and the rule will be executed. If
you combine multiple conditions, the current status (open or closed) of the selected
door contact is monitored.
 Random execution
This condition allows you to create a presence simulation. The selected timespan