66
The color option is only available for Philips Hue Color
products. This option allows you to change the color of
your lamp. Be aware, that changing the color is only
possible while the lamp is switched on. Hence, your
automation required to actions: Firstly, switch the lamp
on and, secondly, change the color. These two actions
need to be combined via the “and” connection.
Dimmer setup (relay with dimmer, light switch V2,and Smarthome lamps
without color function)
The available settings are identical to switch setup. Additionally, you have settings
for dimming (0% - 100% in 10% steps).
Shutter setup
Before you use this option, define the time your shutter requires to open / close in
“Sensors” “List” “Sensor List” for all your shutter relays.
o Open: Opens the connected shutter completely.
o Close: Closes the connected shutter completely.
o Stop: Stops the shutter at its current position
o Level: Allows you to open/close your shutter to a certain degree (in 10%
steps).
Door lock
This action allows you to control your connected Nuki door locks. You can unlock,
lock, or unlatch your lock.
(To connect a Nuki lock, please go to chapter “Settings” “Device integration”
“Nuki”).
Bypass on / off
This action allows you to activate or deactivate the bypass function of the selected
sensor.
This action can only be applied to alarm sensors.
Execute UPIC
This action allows you to send out a saved signal of your universal IR controller.
You need to select the IR controller, as well as, the command you want to send
out.
Trigger alarm
This action allows you to trigger an alarm of the alarm panel.
Thermostat
This action allows you to change the settings of your radiator valve thermostat.
You find the explanation of the individual settings in the radiator valve thermostat
chapter.
Switch group setup
If you defined a group of relays or switches in the menu “Smarthome” “Wireless
Plugs” “Group settings”, this action allows you to control this group according to
the options available for switch setup.
Lamp group setup
If you defined a group of Smarthome lights in the menu “Smarthome” “Wireless
Plugs” “Group settings”, this action allows you to control this group according to
To Next Page
Loading...