67
the options available for lamp setup.
Dimmer group setup
If you defined a group of dimmers in the menu “Smarthome” “Wireless Plugs”
“Group settings”, this action allows you to control this group according to the
options available for dimmer setup.
Shutter group setup
If you defined a group of shutter relays in the menu “Smarthome” “Wireless
Plugs” “Group settings”, this action allows you to control this group according to
the options available for shutter setup.
PIR-camera
This action allows you to request images from all your PIR network cameras in
area 1, area 2, or only from a specific PIR network camera. The PIR network
camera takes three images that are saved in the menu “Smarthome” “Capture”
“Image events”. You can also use the upload function to receive these images
e.g. by mail (“Alarm system” “Report” “Media upload”).
IP-Camera (only for LUPUS cameras LE 20x and LE 9xx series)
First, select the camera which shall perform one of the following actions. You
connect your LUPUS cameras via the menu “Smarthome” “Cameras”. To send
commands to cameras of other manufacturers, you need to know the correct cgi
command and use the action Action URL explained below.
o Start video recording (only LE 20x series): Starts a manual recording of the
camera
o Stop video recording (only LE 20x series): Stops the recording.
o Start PTZ-Tour (only LE 203): Starts the first PTZ tour of the camera.
o Stop PTZ-Tour (only LE 203): Stops the PTZ tour of the camera.
o Activate motion detection: Activates the motion detection of the camera.
o Deactivate motion detection: Deactivates the motion detection of the
camera.
o Send eMail on motion: Activates the e-mail notification when a motion is
detected.
o Don’t send eMail on motion: Deactivates the e-mail notification when a
motion is detected.
o PTZ-Position (only LE 203): Moves the camera to one of the 25 positions
that can be saved in the camera. It is required to set these positions in the
camera before you can use this action.
Action URL
This action allows you to send out an URL command to another device. The
maximal amount of characters is 1000. You can find examples in the chapter
“Examples”.
Push-Notification
This action allows you to send a push notification to your smartphone with a
predefined text.
Change profile
This action allows you to change the Smarthome profile of your alarm panel
(“Smarthome” “Automation” “Profiles”).
To Next Page
Loading...