Lupus Electronics XT 1 Plus - Page 161

161
Please note:
If the signal strength at the place of installation is below 4, we advise to use a ZigBee
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Please note:
 In the menu “Sensor”  “List,” shows the status (on / off) of the relay.
 The single channel relay does not feature a power meter.
 You can control the relay via the menu “Smarthome”  “Wireless Plugs”, or the
menu “Home”  “Wireless Plugs-app”.
 In the menu “Smarthome”  “Automation,” you can set up automation rules for the
relay. You can find examples in the manual of the alarm panel (chapter
Smarthome).
 The single channel relay does not feature a backup battery. In case of a blackout
or power failure, it does not function.
 After a blackout or power failure, the relay returns to its previous state (on / off)
after approx. one minute.
 The single channel relay (like all ZigBee devices) is not compatible with the
wireless repeater and is not saved in the backup file.
 The single channel relay features a ZigBee repeater and automatically enhances
the signal strength of other ZigBee devices.
 Adding a single channel relay allows you to connect 40 additional ZigBee devices
(up to the limit of devices the alarm panel supports).