164
Please note (signal strength):
If the signal strength at the place of installation is below 4, we advise to use a ZigBee
repeater, since it is normal that the signal strength may fluctuate for 2-3 points, thus,
a signal loss is possible.
Please note:
In the menu “Sensor” “List”, shows the status (on / off) of the relays outputs.
The double channel relay does not feature a power meter.
You can control the relay via the menu “Smarthome” “Wireless Plugs”, or the
menu “Home” “Wireless Plugs-app”.
In the menu “Smarthome” “Automation”, you can set up automation rules for the
relay. You can find examples in the manual of the alarm panel (chapter
Smarthome).
In the menu “Smarthome” “Wireless plugs” “Group settings”, you can group
relays in order to control them simultaneously.
The double channel relay does not feature a backup battery. In case of a blackout
or power failure, it does not function.
After a blackout or power failure, the relay returns to its previous state (on / off)
after approx. one minute.
The double channel relay (like all ZigBee devices) is not compatible with the
wireless repeater and is not saved in the backup file.
The double channel relay features a ZigBee repeater and automatically
enhances the signal strength of other ZigBee devices.
Adding a double channel relay allows you to connect 40 additional ZigBee
devices (up to the limit of devices the alarm panel supports).
To Next Page
Loading...