221
you can automatically arm/ disarm the alarm panel. The alarm panel is
automatically armed or disarmed, depending on whether the contact is closed or
open.
o Normally closed
The sensor is normally closed and arms the alarm panel when opened.
o Normally open
The sensor is normally open and arms the alarm panel when closed.
Please note:
o This function forces the immediate arming/ disarming of the alarm panel,
irrespective of the set delay times or possible system errors (if not set differently in
the menu “Alarm system” “Settings” “Area settings” “Force arm
SET/USNET”)! If you switch this setting to “confirm”, you need to confirm the mode
change again within 10 seconds (e.g. lock the door again).
o If you want to use several wireless lockswitch contacts and arm the alarm panel
only when the last door is closed, you should assign the additional attribute “Must
be closed before arming” to all wireless sensor inputs. Additionally, you need to
change the setting “Force arm SET/USNET” to “confirm” in the menu “Alarm
system” “Settings” “Area settings”.
Must be closed before arming
This function is available for door contacts and sensor inputs. If enabled, it is
impossible to arm the area or set it to home mode, if the door contact with this
option enabled is still open.
Please Note:
o It is necessary to set “Arming with failure” to “Confirm” in the menu “Alarm
system” “Settings” “Area Settings” – otherwise this function does not
work.
o Home automation rules and scenarios can arm the alarm panel irrespective
of this setting.
24 HR
If this function is active, the set alarm is triggered irrespective of the alarm mode
of the alarm panel, when the sensor is activated.
To Next Page
Loading...