248
since it is normal that the signal strength may fluctuate for 2-3 points, thus, a signal
loss is possible.
Installation:
There are five holes at the back of the PIR motion detector (three slots, two small
holes) – these are used to install the corner mount
To use the corner mount, use the provided screws to fix the corner mount at a
corner and, then, latch the PIR motion detector V2 onto the corner mount.
You can also screw the PIR motion detector directly onto a wall. We advise to use
the notches at the back of the PIR motion detector V2 as breakpoints for the
screws.
The horizontal angle of the PIR motion V2 detector is 110°.
To Next Page
Loading...