294
Installation:
The status display can be installed in two ways. Either by using the included adhesive
tape, or by using the included screws. Please do not use adhesive tape on rough
surfaces, dirty surfaces or on paint that peels of easily.
Attachment points for the screws
Installation with screws:
1. Open the casing of the status display by unfastening the casing screw (2).
2. On the back of the status display you find two attachment points for the screws.
Pierce them to mark the location for the necessary drillings.
3. Screw the back of the status display onto the wall.
4. Make sure that the front of the status display is hooked into the casing hook and
that it is completely closed.
5. Fasten the casing screw (2) to close the casing.
Please note:
The status display can only be connected to one area.
If you have deactivated the alarm sound for external sirens (“Alarm system”
“Siren settings” “Alarm settings”), the status display will not show the alarm.
If you have set an exit delay, the status display will show the current mode after
the delay has ended.
The status display is not compatible with the wireless repeater and the settings
of the status display cannot be saved in the backup file.
The signal of the status display can be repeated with a ZigBee repeater.
To Next Page
Loading...