306
Please note:
If the signal strength at the place of installation is below 4, we advice to use a
ZigBee repeater, since it is normal that the signal strength may fluctuate for 2-3
points, thus, a signal loss is possible.
Note:
The power consumption in Watt and the state (on/off) is displayed in the menu
“Sensors” “List” “Status”.
You can activate or deactivate the top-hat rail relay manually via the website.
You can set up rules for the activation or deactivation of the top-hat rail relay in the
menu “Smarthome” “Automation”.
After a power failure, the top-hat rail relay returns to the initial state within one
minute.
The top-hat rail relays are not compatible with the wireless repeater and cannot
be saved in the backup file of the alarm panel.
ATTENTION:
Never open the housing. The risk of an electromagnetic shock dangerous to
life is available.
CAUTION:
Only certified electricians or persons instructed in electrical engineering with knowledge
and understanding of electric current and the inherent risks are allowed to execute the
installation.
To Next Page
Loading...