214323 71 Revision B
Figure 3.59: Balance Linkage
7. Place torque wrench (A) on bolt (B).
Figure 3.60: Balance Linkage
8. Position point (D) as follows:
a. Use wrench (A) to move bell crank (B) so that the lower
edge of bell crank is parallel to top-link (C).
b. Check that pointer (D) is lined up with top-link (C).
Bend the pointer, if necessary.
Figure 3.61: Wing Lock in UNLOCK Position
9. Unlock the wings by moving spring handles (A) to the lower
(UNLOCK) position.
OPERATION
To Next Page
Loading...
