992 Matrix PRASAR UCS System Manual
• To answer the Paging call the desired extension user must use Meet Me Paging while the Paging call is
active. For details refer, “Meet Me Paging”.
• If no reply is received via Meet Me Paging, the calling SIP extension goes ON-Hook after the
announcement.
• The system deactivates the speakers of the SIP Extensions.
How to configure
For this feature to work, you must create Page Zones and enable this feature in the Class of Service of the
extensions which are to be allowed this feature.
Allowing Paging in Class of Service
In the default factory settings, Station Basic Feature Template Number 01 is assigned to all the stations of PRASAR
UCS. Station Basic Feature Template 01 is assigned CoS group 01 which has Paging enabled. So, all stations of
PRASAR UCS can page.
If you want to allow Paging to all stations, retain CoS group 01 in Station Basic Feature Template 01.
However, if Paging is to be disallowed to some stations then follow these steps:
a. Define a CoS group with Paging disallowed.
b. Prepare a Station Basic Feature Template with this CoS group applicable in all the “Time Zones”.
c. Assign this new Template to the stations to which Paging is to be disallowed.
Refer the topics “Class of Service (COS)” and “Station Basic Feature Template” for detailed instructions and
programming.
Creating Page Zones
Decide how many Page Zones you want to create. You can create as many as 12 different Page Zones. You can
include up to 32 SIP extensions.
For each Page Zone number, decide and assign the SIP extensions.
On a sheet of paper create a three-column table for each page zone, as shown below. Enter the Type of extension-
SIP, and the Software Port number of the extensions you want to include in the page zone.
Page Zone 1
Member Number Type of Extension
SIP Extension
Port Number
1 SIP 002
2 SIP 003
3 SIP 008
4 SIP 009
To Next Page
Loading...