Matrix PRASAR UCS System Manual 1039
How to configure
• Login as System Engineer.
• Under Configuration, click Redundancy Notification.
• Redundancy Notification Call: Enable this check box if you want the system to place the Redundancy
Notification Call on extension/s after the redundancy process is completed. By default, this check box is
enabled.
• Time Table: A Time Table is a schedule for the three Time Zones, namely: Working Hours, Break Hours,
Non-Working hours for a week
You can define and select the Time Table for the Redundancy Notification Call as per you requirement.
There are 8 different Time Table templates to select from. By default, the Time Table 1 is selected.
In Time Table 1, six days of the week - Monday to Saturday - have working hours from 9:00-18:00,
break hours from 13:00-14:00 hours and non-working hours from 18:00 to 09:00. Sunday is a holiday,
with all three Time Zones set to 00:00 hours.
You may also customize the default Time Table 1 OR customize and assign a different Time Table as per
your requirement. Refer to “Time Tables” for more details.
You can select different landing destinations for each time zone, that is Working Hours (WH), Break Hours
(BH) and Non-working Hours (NH) as per your requirement.
For example, redundancy notification call can be routed to the Operator’s extension during working hours
and the security personnel extension’s during the non-working hours.
• Port Type: Select the landing destination on which you want to place the Redundancy Notification Call. It
may be a dedicated SIP extension or a Routing Group.
If you select routing group as the landing destination for the redundancy notification call, then you must
configure a routing group. To know how to create a routing group, refer to “Routing Group”.
To Next Page
Loading...